Compressed air products Isolation valves, drain traps and ancillaries
5
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2022
TI-P148-03 CMGT Issue 10
CA44S Carbon Steel Air and Gas Trap DN40 and DN50
5.5 47
DIN flange shown
Description The CA44S is an carbon steel ball float air and gas trap. It has a metal valve cone and is available with horizontal flanged connections. The cover will be drilled and tapped ¾ " BSP or NPT for the purpose of fitting a balance line. Body and cover castings are produced by a TÜV approved supplier in accordance with AD-Merkblatt WO/TRD100. Standards This product fully complies with the requirements of the EU Pressure Equipment Directive/UK Pressure Equipment (Safety) Regulations and carries the mark when so required. Certification The product is available with material certification to EN 10204 3.1. Note: All certification/inspection requirements must be stated at the time of order placement. Sizes and pipe connections DN40 and DN50 Standard flanges are: EN 1092-1 PN40 with DIN face-to-face dimensions and ASME 150, ASME 300 and JIS/KS 20K flanges with drilled and tapped bolt holes with DIN face-to-face dimensions. PN and JIS/KS flanges will be provided with BSP balance line and ASME flanges with NPT balance line.
9.5.42
TI-P148-03 CMGT Issue 10
Page 1 of 6
CA44S Carbon Steel Air and Gas Trap DN40 and DN50
Powered by FlippingBook