Boiler house Sample coolers
2
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2025
TI-P403-82 EMM Issue 13
SSC20 Sanitary Sample Cooler
Description The Spirax Sarco SSC20 sanitary sample cooler has been specifically designed for taking high quality chemical, conductivity and microbiological samples quickly and safely from clean/ pure steam, water for injection (WFI) and other high purity media systems. The unit consists of high quality 316L stainless steel components and utilises a counter current flow to maximise cooler efficiency, resulting in a compact, space saving design. The unit is provided with separate mounting brackets and screws to allow simple installation at point of use. Designed, manufactured and approved for Steam and Condensate applications. This product complies with EC1935:2004 Food Contact Materials. It also complies with regulation EC2023:2006 on good manufacturing practice for materials and articles intended to come into contact with food. Surface finish Sample contact surfaces are compliant to current ASME BPE requirements. Ra Maximum 0.5 µm Ra (20 µin Ra). Principal features: - Internal surface finish of coil better than 0.5 µm Ra (20 µin Ra) to ensure high sterility. - Coil manufactured from fully traceable 316L stainless steel. - Self-draining design to eliminate sample retention. - Fully sterilisable /autoclavable - to ensure integrity of unit between samples. - Separate mounting brackets and screws to facilitate simple installation. WARNING: The SSC20 is not sterile as supplied. Sterilisation in Place (SIP) prior to testing or at periodic intervals. It may be appropriate to sterilise the SSC20 to ensure that sample integrity is maintained during testing. For further details on SIP, to include recommended installation, refer to Spirax Sarco. Example of Customer sterilization process (recommendation) - Expose to saturated steam for 20 minutes at 122 °C (252 °F), or 5 minutes at 134 °C (273 °F). The inlet temperature should be high enough so that the outlet too can be fully sterilised. Packaging All packaging of the SSC20 sanitary sample cooler is conducted in an environment segregated from other non stainless steel manufacture and is in accordance with ASME BPE. - Sample inlet and outlet connections are capped. - Each Sample Cooler is individually packaged within an "ISO CLASS 7" clean environment with cooling water ends and sampling ends fitted with protective end cap. The product is then sealed in a protective plastic bag.
Sample IN
2.6 7
Clamp
Standards The SSC20 has been manufactured and built in general accordance with ASME BPE standards.
Sample OUT
TI-P403-82 EMM Issue 13
Page 1 of 5
SSC20 Sanitary Sample Cooler
Powered by FlippingBook