Pipeline ancillaries Strainers and filters
10
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2025
TI-P169-06 CMGT Issue 5
TP1, TP2, TP3 and Spacer Ring Stainless Steel Temporary Strainers
Description Temporary strainers have been designed to fit between two flanges and are generally used during commissioning and start-up to remove any course debris. They are available in three designs (TP1, TP2 and TP3 as illustated below) to suit a wide range of fluids for applications in process lines, hot water systems, steam and condensate systems etc. The standard screens are manufactured using 304L or 316L stainless steel and have 3 mm perforations. Other perforations or material of construction are available on request. Temporary strainers are not intended to be used for permanent applications. Contact Spirax Sarco when permanent applications are required. After commissioning and start-up the temporary strainer should be removed from the pipeline and replaced with a spacer ring. Standards These products fully comply with the requirements of the European Pressure Equipment Directive 2014/68/EU and carry the mark when so required. Certification These products are available with certification to EN 10204 3.1 and NACE approval. Note : All certifications/inspections requirements must be stated at the time of order placement.
TP1 Conical
Spacer ring
7.5.50
10.6 1
TP2 Truncated conical
TP3 Flat screen
TI-P169-06 CMGT Issue 5
Page 1 of 5
TP1, TP2, TP3 and Spacer Ring Stainless Steel Temporary Strainers
Powered by FlippingBook