Steam traps Ball float
8
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2023
TI-P142-01 CMGT Issue 15
FT47 SG Iron Ball Float Steam Traps (DN15 to DN50)
FT47 DN15, DN20 and DN25 DN15 shown
5.5.88
FT47-C
8.5 101
FT47 DN40 and DN50 DN50 shown
Description The FT47 is an SG iron ball float steam trap with integral automatic air venting facility. It is available with horizontal flanged connections as well as vertical flanged connections, designated FT47V. As an option in the horizontal version up to 21 bar g, a manually adjustable needle valve can be added for use as a steam lock release designated FT47-C. If required, the cover can be drilled and tapped 3/8 " BSP or NPT for the purpose of fitting a drain cock. For the horizontal DN50 only, body and cover castings are produced by a TÜV approved foundry. Standards This product fully complies with the requirements of the Pressure Equipment Directive (PED) and carries the mark when so required. Certification This product is available with a manufacturers' Typical Test Report. As an available option certification to EN 10204 3.1 can be supplied. Note: All certification/inspection requirements must be specified at the time of order placement.
TI-P142-01 CMGT Issue 15
Page 1 of 7
FT47 SG Iron Ball Float Steam Traps (DN15 to DN50)
Powered by FlippingBook