Steam traps Ball float
8
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2021
TI-P615-03 CMGT Issue 6
IFT57 SG Iron Ball Float Steam Trap with Integral Spiratec Sensor and Flanged Connections
IFT57H DN40 (horizontal shown)
IFT57V DN15 (vertical shown)
Description The IFT57 is an SG iron ball float steam trap having stainless steel working internals, an integral Spiratec sensor (SSI) for steam leakage detection and built-in automatic air venting facility for the prompt removal of large condensate loads from steam systems. The trap is supplied with integrally flanged connections and can be maintained without disturbing the pipework.
8.5 159
Vertical flanged connections, designated IFT57V are available. Flow direction for the horizontal trap is from right to left only when facing the body. For vertically orientated traps the flow is downwards only. The body and cover are produced by TÜV approved foundries.
Available options: IFT57H - Horizontal flow IFT57V - Vertical flow Sensors are compatible with Spiratec indicators, automatic monitors and test points:
R1 (single trap) remote set point, R12 (12 trap) remote test point, Type 30 hand held indicator, R16C (16 trap) automatic steam trap monitor with PNP/NPN output where applicable. Capsule The BP99 /32 capsule used in the air vent assembly is suitable for 150 ° C superheat @ 0 bar g and 50 ° C superheat @ 32 bar g. Optional extras The top of the cover can be drilled and tapped " BSP or NPT for the purpose of fitting a balance line if requested at the point of order. The bottom of the cover can be drilled and tapped " BSP or NPT for the purpose of fitting a drain cock if requested at the point of order.
Page 1 of 7
Powered by FlippingBook