Steam traps Thermodynamic
8
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2025
TI-S01-03 CMGT Issue 12
TD42L and TD42H Thermodynamic Steam Traps
Description The TD42L and TD42H are maintainable thermodynamic steam traps. The TD42L is specifically designed for relatively small condensate loads and therefore is ideal for mains drainage applications. For process type loads the TD42H is available. For those applications where the release of air is a concern, an anti-air-binding disc is available i.e. TD42LA and TD42HA. All external body surfaces have an electroless nickel preparation (ENP) which is both energy saving and oxidation resistant. Standards These products fully comply with the requirements of the European Pressure Equipment Directive 2014/68/EU. Certification This product is available with a manufactures' Typical Test Report. Note: All certification/inspection requirements must be stated at time of order placement. Sizes and pipe connections TD42L 3/8 ", ½", ¾" and 1" screwed BSP T Rp (ISO 7-1) or NPT
5.7.28
½", ¾" and 1"
screwed BSP T Rp (ISO 7-1) or NPT screwed BSP T Rp (ISO 7-1) or NPT screwed BSP T Rp (ISO 7-1) or NPT
TD42H
3/8 ", ½", ¾" and 1"
TD42LA
TD42HA
½" and ¾"
Optional extras Insulating cover: to prevent the trap being unduly influenced by excessive heat loss such as when subjected to low outside temperatures, wind, rain etc. Integral blowdown valve: a BDV1 or BDV2 can be fitted to the strainer cap, alternatively the strainer cap can be drilled, tapped and plugged 3/8 " BSP T Rp (ISO 7-1) or NPT.
8.7 33
TI-S01-03 CMGT Issue 12
Page 1 of 5
TD42L and TD42H Thermodynamic Steam Traps
Powered by FlippingBook