Steam traps Thermodynamic
8
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2025
TI-P187-03 CMGT Issue 7
UTDS46M Stainless Steel Thermodynamic Steam Trap for use with Pipeline Connectors Description The UTDS46M is a workshop maintainable stainless steel thermodynamic steam trap with integral strainer, integral air vent, insulation cover and a replaceable seat. It has been specifically designed for low capacity applications up to 46 bar g (667 psi g). The UTDS46M is attached to a suitable pipeline connector by two screws for quick and easy installation, and replacement. Optional extra At extra cost a BDV2 integral blowdown valve can be pre-fitted to the strainer cap but must be specified at the time of order placement. Standard This product fully complies with the requirements of the European Pressure Equipment Directive 2014/68/EU. Certification This product is available with certification to EN 10204 3.1. Note: All certification / inspection requirements must be specified at the time of order placement.
UTDS46M shown connected to a PC10HP pipeline connector
8.7 75
Pipeline connector options The UTDS46M can be fitted to a variety of pipeline connectors: PC10HP Straight connector
ASME 600
(TI-P128-10)
PC3_
Straight connector with one piston isolation valve
ASME 600
(TI-P128-02)
PC4_
Straight connector with two piston isolation valves
ASME 600
(TI-P128-03)
See the relevant Technical Information sheet as listed above for details of the connections available for each pipeline connector.
TI-P187-03 CMGT Issue 7
Page 1 of 6
UTDS46M Stainless Steel Thermodynamic Steam Trap for use with Pipeline Connectors
Powered by FlippingBook