Pipeline ancillaries Ball valves
10
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2025
TI-P133-70 CMGT Issue 5
M10Hi ISO Ball Valve DN¼" to DN2½"
Description The M10Hi ISO three-piece body ball valve has a lockable handle and ISO mounting as standard and features a special ball, which has received a surface hardening. It can be used on applications that use steam and other industrial fluids for services ranging from vacuum to the higher temperatures and pressures. The M10Hi ISO has been designed for use as an isolating valve, not a control valve, and can be serviced without removal from the pipeline. ISO mounting The integral ISO body mounting allows the valve to be automated without losing seal integrity, as the body does not require disassembly. Manual to remote control may therefore be easily accomplished by the ISO range of Spirax Sarco ball valves. Available types M10Hi2 ISO Zinc plated carbon steel body and caps. M10Hi3 ISO Stainless steel body and caps. M10Hi4 ISO Complete stainless steel construction. Note: The nomenclature will be followed with either FB (full bore) or RB (reduced bore) and needs to be stated when placing an order. Standards This product fully complies with the requirements of the Pressure Equipment Directive (PED) and carries the mark when so required. Certification This product is available with certification to EN 10204 3.1. Note: All certification/inspection requirements must be stated at the time of order placement. Options - Self-venting ball. - Extended stem 100 mm (4") to allow full insulation. - Fully degreased under request (i.e: Oxygen application). Technical data Flow characteristic Modified linear Port Full and reduced bore versions Leakage test procedure to ISO 5208 (Rate A)/EN 12266-1 (Rate A)
10.3 57
TI-P133-70 CMGT Issue 5
Page 1 of 7
M10Hi ISO Ball Valve DN¼" to DN2½"
Powered by FlippingBook