Pipeline ancillaries Strainers and filters
10
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2025
TI-P160-02 CMGT Issue 15
Fig 36 Austenitic Stainless Steel Strainer
Description The Fig 36 is an austenitic stainless steel integrally flanged Y-type strainer.
The standard stainless steel screen in the DN15 to DN80 (½" - 3") size range has 0.8 mm perforations, in the DN100 to DN200 (4" to 8") size range it has 1.6 mm perforations. Other perforations, mesh sizes and monel screens are available as options. The strainer cap can be drilled and tapped for blowdown and drain valves if required. Standards This product fully complies with the requirements of the European Pressure Equipment Directive 2014/68/EU and carries the mark when so required.
Certification The product is available with a manufacturers' Typical Test Report as standard and EN 10204 3.1 for body and cap by special request. Note: All certification/inspection requirements must be stated at the time of order placement. Sizes and pipe connections DN15, DN20, DN25, DN32, DN40, DN50, DN65, DN80, DN100, DN125, DN150 and DN200 (½", ¾", 1", 1¼", 2", 1½", 3", 4", 5", 6" and 8") Standard flange: EN 1092 PN16, PN25 and PN40 (DN15 to DN50 (½" to 2")) EN 1092 PN25 and PN40 (DN65 to DN150 (2½" to 6")) EN 1092 PN40 (DN200 (8")) ANSI Class 150 and ANSI Class 300 (All sizes) JIS/KS flanges are available on request.
7.6.56
Optional extras
1.6 mm (DN15 to DN80 (½" to 3")) 3.0 mm (DN15 to DN200 (½" to 8"))
Perforations
Stainless steel screens
10.6 67
Mesh
40, 100, 200
Strainer screens
0.8 mm (DN15 to DN80 (½" to 3")) 1.6 mm (DN100 to DN200 (4" to 8")) 3.0 mm (DN15 to DN200 (½" to 8"))
Perforations
Monel screens
Mesh
100
Strainer size
Blowdown valve
Drain valve
DN15 (½")
¼ " ½ "
¼ " ½ " ¾ " ¾ " ¾ "
Blowdown or drain valve connections The cap can be drilled to the following sizes to enable a blowdown or drain valve to be fitted.
DN20 and DN25 (½" and 1")
DN32 and DN40 (1¼" and 1½")
1"
DN50 to DN125 (2" and 5")
1 ¼ "
DN150 and DN200 (6" and 8")
2"
TI-P160-02 CMGT Issue 15
Page 1 of 6
Fig 36 Austenitic Stainless Steel Strainer
Powered by FlippingBook