Pipeline ancillaries Separators and insulation jackets
10
Local regulations may restrict the use of this product to below the conditions quoted. In the interests of development and improvement of the product, we reserve the right to change the specification without notice. © Copyright 2018
TI-P023-49 CMGT Issue 3
IJ-S1 Insulation Jacket for S1 Separators
Description The IJ-S1 is a range of insulation jackets for fitting to separator type S1. The jackets are of a one-piece design. TI-P023-48 gives details of a payback calculator based on the energy saving to be made by fitting an insulation jacket. Available types Available as a one-piece jacket with velcro fastening, for fitting to all sizes of S1 separator. IJ-S1 to fit separator S1 DN15 to DN25. Limiting conditions Maximum metal surface temperature 220 °C Thermal conductivity 0.044 W/m K at 100 °C
1
2
Materials No. Part
Material
1 2 3 4 5 6
Inner and outer face
Silicone rubber coated glass fibre
Insulation
Mineral fibre
Stitching
Polyester cotton
Sealing
Velcro
7.7.2
Drawcords
Nylon
6
Label
Nylon
Installation Once the separator has been installed, the insulation jacket can be fitted as follows: Place the top of the jacket over the top of the separator. Undo the velcro flaps and slide the jacket down over the separator. Fasten the two lower flaps. Then fasten the top flap. Finally, tie the drawcord around the outlet pipe.
4
3
10.7 5
Important note: Both the inner/outer face and insulation are made with a bonded aluminium foil. At a temperature of 120 °C the adhesive bonding the aluminium will start to degrade and delamination of the foil will occur at 150 °C to 170 °C. Scorching of the internal fabric may occur at 150 °C. Neither of these reactions will impair the performance. Removal Before removing the jacket, check if the separator is in service. If it is, the metal surface will be hot enough to burn and suitable protective clothing (e.g. gloves) should be worn. Removal is the reverse procedure to the above. 5
0230250/3
Powered by FlippingBook