Installation Once the separator has been installed, the insulation jacket can be fitted as follows: IJ-S5 and IJ-S6 Place the jacket centrally on the left hand side of the separator. Undo the middle velcro flap, slide the jacket down over the flanged/threaded connection and pull velcro flap into secure position. Wrap front and back of jacket around separator and secure fully by using the top and bottom velcro flaps. Finally, pull and tie the top and bottom drawcords to minimise any gaps that would allow air to flow through or allow ingress of water. IJ-S5-H and IJ-S6-H Place the jacket centrally on the left hand side of the separator. Undo the middle buckle straps, slide the jacket down over the flanged/threaded connection and pull the buckle straps into secure position. Wrap front and back of jacket around separator and secure fully by using the top and bottom buckle straps. Finally, pull and tie the top and bottom drawcords to minimise any gaps that would allow air to flow through or allow ingress of water. Flange insulation jackets The separator insulation jacket should be fitted before any flange insulation jackets. Important note: Both the inner/outer face and insulation are made with a bonded aluminium foil. At a temperature of 120 °C the adhesive bonding and the aluminium foil will start to degrade and delamination of the foil will occur at between 150 °C to 170 °C. Scorching of the internal fabric may occur at 150 °C. Neither of these reactions will impair the performance. Pipeline ancillaries Separators and insulation jackets
10
Dimensions/mass (approximate) in mm and kg IJ-S5 and IJ-S6 Size A B Insulation thickness
Mass
DN15 and DN20
508 508
50
0.90
DN25 and DN32
711 686
50
1.64
DN40 and DN50
762 838
50
2.42
The diagram below shows the unfolded dimensions of the jacket
B
A
115
IJ-S5-H and IJ-S6-H Size
A B Insulation thickness
Mass
DN15 and DN20
508 508
50
1.06
7.7.46
DN25 and DN32
736 686
50
2.00
DN40 and DN50
788 838
50
2.60
The diagram below shows the unfolded dimensions of the jacket
A
10.7 47
B
TI-P138-01 CMGT Issue 7
Page 3 of 4
IJ-S5, IJ-S6, IJ-S5-H and IJ-S6-H Insulation Jackets for S5 and S6 Separators
Powered by FlippingBook